Cheerfull days

むむ，これならX40でもいいかも．

しかし，1週間ぐらい前に，IBMダイレクトでX40の旧型が13万ぐらいで叩き売られてたのを目をつけていたのですが，現在ではなくなっているようです．

USB Floppyが見当たらないなぁ．

• FreeBSD 5.3-RELEASEのインストールFDを用意した
• 普通にboot→dmesgの途中で停止(pci0: のあたり?)
• ACPIをdisableしてboot→同じ
• verbose modeでboot→「FOUND->vender=0x8086, dev=0x3582, revid=0x02」のあたりで停止
• このへんでIRC経由で「そういや最近ACPIが直った」という神意見があったので，1/26のsnapshotに代える
• やっぱり変化なし

どーも，i855GMをprobeするあたりでしくじっている?
boot -v の出力を手で写してみる．

 pcib0: matched entry for 0.2.INTA (src \_SB_.LNKA)
 pcib0: possible interrupts: 10
 ACPI PCI link arbitrated settings:
 \_SB_.LNKC (references 2, priority 6763):
         interrupts:        11     5     7     6     4     3
         penalty:           40    90  5040  5040  5040  5040
 \_SB_.LNKB (references 1, priority 3381):
         interrupts:        11     5     7     6     4     3
         penalty:           40    90  5040  5040  5040  5040
 \_SB_.LNKH (references 1, priority 3381):
         interrupts:        11     5     7     6     4     3
         penalty:           40    90  5040  5040  5040  5040
 \_SB_.LNKA (references 2, priority 40):
         interrupts:        10
         penalty:           20
 pcib0: slot 2 INTA routed to irq 10 via \_SB_.LNKA
 found-> vendor=0x8086, dev=0x3582, revid=0x02
         bus=0, slot=2, func=0
         class=03-00-00, hdrtype=0x00, mfdev=1
         cmdreg=0x0007, statreg=0x0090, cachelnsz=0 (dwords)
         lattimer=0x00 (0 ns), mingnt=0x00 (0 ns), maxlat=0x00 (0 ns)
         intpin=a, irq=10
         powerspec 1  supports D0 D1 D3  current D0
         map[10]: type 3, range 32, base 00000000, size 27, memory disabled

ここで止まります．

通りすがりの方より，有益な情報をいただきました!

 Dynabook にFreeBSDですが、
 /boot/loader.conf に以下のおまじない書いてもダメでしょうか？
 hint.elcr.0.disabled=1
 hw.pci.enable_io_modes=0

 あと、suspend/resumeにはこれも必要かも
 hw.acpi.reset_video=0

やってみたら無事起動しました!

Copyright (c) 1992-2004 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 5.3-RELEASE-p5 #0: Sat Jan 29 07:26:08 JST 2005
    togawa@nayuki.vegalta.org:/usr/obj/usr/src/sys/NAYUKI
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Pentium(R) M processor 1000MHz (997.50-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x695  Stepping = 5
  Features=0xa7e9f9bf<FPU,VME,DE,PSE,TSC,MSR,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,TM,PBE>
real memory  = 250871808 (239 MB)
avail memory = 235823104 (224 MB)
npx0: [FAST]
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <TOSHIB 750> on motherboard
acpi0: Power Button (fixed)
Timecounter "ACPI-safe" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0xd808-0xd80b on acpi0
cpu0: <ACPI CPU (3 Cx states)> on acpi0
acpi_tz0: <Thermal Zone> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
pci0: <base peripheral> at device 0.1 (no driver attached)
pci0: <base peripheral> at device 0.3 (no driver attached)
agp0: <Intel 8285xM (85xGM GMCH) SVGA controller> port 0xeff8-0xefff mem 0xd0000000-0xd007ffff,0xd8000000-0xdfffffff irq 10 at device 2.0 on pci0
agp0: detected 16252k stolen memory
agp0: aperture size is 128M
pci0: <display> at device 2.1 (no driver attached)
uhci0: <Intel 82801DB (ICH4) USB controller USB-A> port 0xcfe0-0xcfff irq 10 at device 29.0 on pci0
uhci0: [GIANT-LOCKED]
usb0: <Intel 82801DB (ICH4) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1: <Intel 82801DB (ICH4) USB controller USB-C> port 0xcf80-0xcf9f irq 11 at device 29.2 on pci0
uhci1: [GIANT-LOCKED]
usb1: <Intel 82801DB (ICH4) USB controller USB-C> on uhci1
usb1: USB revision 1.0
uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
ucom0: Kyocera Corporation Modem driver for Kyocera PS, rev 1.10/1.00, addr 2, iclass 2/136
ucom0: data interface 1, has CM over data, has break
ucom0: status change notification available
pci0: <serial bus, USB> at device 29.7 (no driver attached)
pcib1: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci1: <ACPI PCI bus> on pcib1
fxp0: <Intel 82801DB (ICH4) Pro/100 VE Ethernet> port 0xcf40-0xcf7f mem 0xcfeff000-0xcfefffff irq 11 at device 8.0 on pci1
miibus0: <MII bus> on fxp0
inphy0: <i82562ET 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
fxp0: Ethernet address: 00:08:0d:7e:d1:62
cbb0: <ToPIC100 PCI-CardBus Bridge> at device 11.0 on pci1
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb1: <ToPIC100 PCI-CardBus Bridge> at device 11.1 on pci1
cardbus1: <CardBus bus> on cbb1
pccard1: <16-bit PCCard bus> on cbb1
pci1: <base peripheral> at device 13.0 (no driver attached)
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH4 UDMA100 controller> port 0xbfa0-0xbfaf,0x376,0x170-0x177,0x3f6,0x1f0-0x1f7 irq 11 at device 31.1 on pci0
ata0: channel #0 on atapci0
ata1: channel #1 on atapci0
pci0: <multimedia, audio> at device 31.5 (no driver attached)
pci0: <simple comms> at device 31.6 (no driver attached)
acpi_button0: <Power Button> on acpi0
acpi_lid0: <Control Method Lid Switch> on acpi0
acpi_cmbat0: <Control Method Battery> on acpi0
acpi_cmbat1: <Control Method Battery> on acpi0
acpi_acad0: <AC Adapter> on acpi0
acpi_toshiba0: <Toshiba HCI Extras> on acpi0
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: [GIANT-LOCKED]
psm0: model GlidePoint, device ID 0
orm0: <ISA Option ROMs> at iomem 0xe0000-0xeffff,0xc0000-0xcffff on isa0
pmtimer0 on isa0
ppc0: parallel port not found.
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250 or not responding
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounter "TSC" frequency 997503782 Hz quality 800
Timecounters tick every 10.000 msec
ad0: 38147MB <TOSHIBA MK4004GAH/JA121A> [77506/16/63] at ata0-master UDMA100

いわゆる「Dynabook SSの画面の黒いシミ」は，保証の範囲で直るらしい． ということで，修理工場行き．ついでに，ILWのシールが矧がれかけていたのも直してもらうことにする．

13:20にいったら既に終了してました．

あきらかに「白Tシャツに文字をプリントしただけ」で，夏でも使えないので買えません． 優勝記念マフラーがあったほうが使いでがあると思われ． 来年は考えてください>ラグビー部の中の人

東芝府中の一方的なペース．ほとんど隙をあたえずに勝利． なお，神戸製鋼のAWAYユニフォームは，青地に腋の下が黄色という， まるでどこかのサッカーチームのようだったので，とても涙無くしては(以下略
ちなみに，準決勝のもう1試合のトヨタ自動車vsヤマハ発動機は，スコア，トライ数，トライフォーポイントゴールの成功数も同じだったため，抽選でヤマハ発動機が決勝に進出．この時点で，ヤマハ発動機の「マイクロソフトカップ枠」による全日本選手権出場が決定(東芝府中は既にトップリーグ枠で出場を決定しているので)．

gimpのscript-fuがcore dumpするようになったので，レベル調整が手動になって面倒です．